Common Plumbing Problems That You Need To Call An Expert

Do you have trouble flushing your toilet? Is there an issue with the water pressure in your shower? If you’re a homeowner, you’ll have to deal with such plumbing problems sooner or later. However, there’s no reason to be concerned: If you have the right tools and know-how, you can handle several common plumbing problems on your own.

It’s preferable to hire a professional if you’re unsure how to handle a situation or if the problem is serious. Here are the three most common plumbing problems that necessitate a plumber’s assistance, as well as the causes:

Leaking/ Dripping Faucets

Water waste is the most evident drawback of a leaky faucet. There are 86,400 drips each day if the faucet drips once every second. That’s 5.7 gallons of wasted water every day, based on a drip rate of 15,140 drops per gallon. That’s about 2,000 gallons each year, or roughly 8 tonnes of water, literally flushed down the toilet.

These are just the figures for a single dripping faucet. The trash quickly builds up if there are several leaking faucets in the residence. Even if you have a low-flow faucet, you’re still wasting a lot of water.

When Should You Hire a Plumber?

If you don’t have any plumbing skills, hire experienced professionals like Plumbing & Pipeline Solutions Adelaide to replace the washer. If the project is too big or you don’t want to clean up, they can help you fix leaking pipes.

What Causes the Plumbing Problem: 

A leaky faucet is usually caused by a broken washer that forms the tap’s seal. Tearing, dislodging, and stiffening are examples of damage. The washer no longer seals tightly due to this damage, enabling small amounts of water to leak from the faucet. 

Over time, the valve seat could also degrade or tarnish. A leak in your pipes is more likely to occur at a joint. Leaks might be caused by deterioration, movement, high water pressure, or other issues.

Water Heater Issues

The problem may go undetected until you’re in the shower and the water suddenly turns chilly. A variety of factors can cause the failure of a water heater. The problem may go undetected until you’re in the shower and the water suddenly turns cold. Water heaters can fail for a multitude of reasons. If the pilot light goes out, you may have to start over. Tank sediment buildup may also pose a problem. At other times, the thermostat may be to blame.

An expert should service your water heater unless it’s a simple issue like the pilot light needing to be reset.

What Causes the Plumbing Problem:

Water heater problems, such as a lack of hot water, are sometimes caused by leaks. Mineral deposits can also wreak havoc on water heaters. The deposits can lower the water heater’s efficiency, limiting the amount of hot water available in your home. Sediment can also generate weird noises from your water heater, caused by the sediment heating up and bursting or scale build-up on the heating elements.

When Should You Hire a Plumber?

Call an expert plumber unless the problem is straightforward to remedy when you have water heater problems, such as relighting the pilot light or adjusting the water heater thermostat. Water heaters can be dangerous, and repairs can be costly, so it’s best to leave it to the pros.

Low Water Pressure

There may be a problem with the water pressure in your home if your water drips rather than gushes out of the faucet. This is a common problem in older houses and apartments. Low water pressure is caused by various factors, the most common of which are leaking pipes that have been cracked, worn, or corroded over time.

What Causes the Plumbing Problem?

Silt and mineral deposits build up on shower aerators, leading to reduced water pressure in the shower. Immerse the aerator in vinegar to decontaminate it. You can soak the showerhead in vinegar or buy a new one if the problem stems from the shower.

Install a filter system to keep minerals out of your pipes and prevent future build-up. Pipes should be checked regularly to detect and repair leaks as soon as possible.

When Should You Hire a Plumber?

 If your water pressure suddenly drops or you can’t find the source of the problem, call a plumber. This is the indication of a leaking pipe. If you detect a progressive drop inflow, but it isn’t due to a problem with your aerators, you may have a build-up or corrosion problem in your pipes. This also necessitates the hiring of a plumber to replace or repair the damaged components.

Don’t Let Time Drip!

Over and above, water availability is essential, and any delays in repairing the smallest issue may widen the scope of bigger damages. Bottom line, don’t wait to get the pipes fixed asap!

Leave a Reply